Download Workshop Manual Service
Transcript
Audi A8 2003 ➤ Auxiliary Heater - Edition 03.2008 ♦ Auxiliary/supplementary heater fully installed and connected to the vehicle electrical system ♦ All auxiliary/supplementary heater fuses OK as per current flow diagram ⇒ Current flow diagrams, Electrical fault finding and Fitting locations ♦ Encoding and adaption of the supplementary heater control unit -J364- OK ⇒ "Guided fault-finding" function of vehicle di‐ agnostic, testing and information system VAS 5051 ♦ Auxiliary/additional heater off Preparation – With the ignition switched off, connect up the vehicle diagnos‐ tic, testing and information system -VAS 5051 A- , for example, with the diagnostic wire -VAS 5051/5A- to the 16-pin diagnos‐ tic socket in the vehicle ⇒ "Guided fault-finding" function of purposes, in part or in whole, is not Protected by copyright. Copying for private or commercial vehicle diagnostic, testing andunless information 5051 . guarantee or accept any liability permitted authorised bysystem AUDI AG. VAS AUDI AG does not with respect to the correctness of information in this document. Copyright by AUDI AG. – Switch on ignition (vehicles with auxiliary/supplementary heat‐ er). – Start engine (vehicles with diesel engine with additional heater only, without “auxiliary heater” optional extra). Note ♦ Auxiliary/additional heater self-diagnosis can only be started with ignition on ( data bus diagnostic interface -J533- is only active after switching on ignition). Once auxiliary/additional heater has switched to diagnostic mode, self-diagnosis can be continued with ignition switched off. ♦ Vehicles with a diesel engine with supplementary heater only (no “Auxiliary heater” optional extra) are not fitted with a cir‐ culation pump -V55- . On such vehicles the engine must be running to circulate the auxiliary/supplementary heater coolant and to prevent overheating. – Select the “Guided fault-finding” function ⇒ "Guided fault-find‐ ing" function of vehicle diagnostic, testing and information system VAS 5051. – Read out the fault memories of all systems with self-diagnosis capability, paying particular attention to the following vehicle systems ⇒ "Guided fault-finding" function of vehicle diagnos‐ tic, testing and information system VAS 5051 : ♦ Dash panel insert ♦ Air conditioner/heater electronics ♦ Supplementary/auxiliary heater ♦ Energy management control unit -J644♦ Data bus diagnostic interface -J533– Eliminate the cause of any faults displayed in the vehicle sys‐ tems and erase the fault memory ⇒ "Guided fault-finding" function of vehicle diagnostic, testing and information system VAS 5051. – Select the supplementary heater control unit -J364- in the “Guided fault-finding” function ⇒ "Guided fault-finding" func‐ tion of vehicle diagnostic, testing and information system VAS 5051. 40 Rep. Gr.82 - Auxiliary heating