Download System One Description, Installation, and APWIN Guide

Transcript
Specifications
System One Generator Specifications
2.1.3 Distortion
Measured with a passive notch filter and spectrum analyzer. Valid for
any Rload >300 Ω.
3
20 Hz – 20 kHz
0.0005% (–106 dB)
10 Hz – 100 kHz
0.0050% (–86 dB)
2.1.4 Output Related
Configurations
Balanced, unbalanced, or common-mode test (same
as balanced except generator is connected between
the output common and source impedance center
tap).
Source Impedance
50 – 150 – 600 Ω balanced, or 25 – 600 Ω
4
unbalanced ; ±1 Ω. Source impedance does not
change with output OFF.
Maximum Rated Floating
Voltage
42 V peak ac, 60 V dc. True transformer isolation.
2.1.5 Auxiliary Signals
Sync Output
LSTTL-compatible squarewave signal for triggering
stable oscilloscope displays with all signals.
Monitor Output
Ground-referenced replica of the generator signal.
Nominally 2.8 Vpp amplitude, Rout = 560 Ω.
Trigger/Gate Input
LSTTL-compatible input for use with the tone burst
option.
2.1.6 Dual Output Related (SYS-22 and SYS-20 only)
SYS-22 and SYS-20 configurations provide a second switchable
generator output. Frequency, amplitude, impedance, and mode selection
apply to both outputs simultaneously. Both outputs must be properly
terminated in the A & B and A & –B modes for correct amplitude
calibration using dBm or Watts units.
Output Modes
A only, B only, A & B, A & –B, or OFF
Output Separation
110 dB to 20 kHz
2
Maximum Output Power
(both channels loaded)
3
Into 600 Ω
+29.4 dBm each load, Rs = 50; +24.3 dBm each
load, Rs = 600.
Into 150 Ω
+24.0 dBm each load, Rs = 50
25 Hz if output open circuit voltage exceeds 20 Vrms balanced, or 10 Vrms unbalanced.
4
Specify option EURZ to substitute <40 – 200 – 600 Ω balanced, <20 – 600 Ω unbalanced
impedance selections.
2-2
System One Description/Installation/APWIN Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com