Download NX-200

NX-200
SYSTEM SET-UP
Merchandise received
License and frequency allocated by FCC
Frequency range (MHz)
RF power
Type
DTMF keypad
TX/RX 136~174
5W
NX-200 K
No
TX/RX 136~174
5W
NX-200 K2
Yes
Choose the type of transceiver
A personal computer, programming interface (KPG-36/36A),
USB adapter(KCT-53U), and programming software (KPG-111D)
are required for programming.
(The frequency, and signaling data are programmed for the transceiver.)
Transceiver programming
YES
Are you using the optional antenna?
NO
KRA-22 or KRA-26
Optional antenna
(Option)
YES
Are you using the speaker microphone?
NO
KMC-25/KMC-41/KMC-42W
Speaker microphone
or
KMC-38GPS
GPS speaker microphone
(Option)
Are you using the voice guide & storage unit?
YES
VGS-1
See page 7.
(Option)
NO
Delivery
REALIGNMENT
1. Modes
User mode
Panel test mode
PC mode
Firmware
programming mode
Function
Mode
User mode
For normal use.
Panel test mode
Used by the dealer to check the fundamental characteristics.
Panel tuning mode
Data programming mode
PC test mode
Clone mode
Firmware version information
PC tuning mode
Panel tuning mode
Used by the dealer to tune the transceiver.
PC mode
Used for communication between the transceiver and PC.
Data programming
mode
Used to read and write frequency data and
other features to and from the transceiver.
PC test mode
Used to check the transceiver using the PC.
This feature is included in the FPU.
See pages 45 to 57.
Firmware programming mode
Used when changing the main program of
the flash memory.
Clone mode
Used to transfer programming data from
one transceiver to another.
Firmware version
information
Used to confirm the internal firmware version.
3