Download CR Service Manual

Transcript
Page 27 of 75
2.
Sliding the bracket at the back of the iCR dual cover onto the iCR unit. Put one
screw in the middle to hold it and then one screw in the top and one in the
bottom (6x32 3/8th flat head Phillips).
3.
Screw in 2 10x32 ½ inch Phillips-flat head screws into the top of the iCR dual unit.
4.
Move to the front of the unit and place one 10x32 ½ inch Phillips-truss head
screws into the lower right hand side of the CR.
iCRco
20406 Earl Street, Torrance CA 90503 Tel (310) 921-9559 Fax (310) 921-2559