Download Specs

SECTION 19: START-UP PROCEDURES
SECTION 19: START-UP PROCEDURES
DANGER
Electrical Shock Hazard
Severe Injury Hazard
Disconnect electric before service.
Do not enter equipment while in operation.
More than one disconnect switch may be
required to disconnect electric from
equipment.
Equipment may start automatically.
Equipment must be properly grounded.
Installation, operation and service must be
done by a trained technician only.
Do not operate with door open.
Failure to follow these instructions can result in death, electrical shock or injury.
WARNING
Explosion Hazard
Carbon Monoxide
Hazard
Leak test all components of equipment Do not recirculate air
from the heated
gas piping before
space over burner.
operation.
Air supply to burner
must be from outside.
Gas can leak if
piping is not
installed properly.
Falling Hazard
Use proper safety
equipment and
practices to avoid
falling.
Do not use any part
of equipment as
support.
Burn Hazard
Allow equipment to
cool before service.
Internal components
of equipment may
still be hot after
operation.
Do not high pressure
test gas piping with
equipment
connected.
Failure to follow these instructions can result in death, injury or property damage.
117