Download SERVICt:: TEXTBOOK

It/STALLI NG ALI GNMENT TOOL
/
(
- - - - - - - - - - ,\
I
I
I
I
I
i
I
I
I
I
I
I
3
~
JDM-81
1 - - - - - - - - - - 11. 4 7"----------~
CHECKING CLUTCH ASSEMBLY
1.
Slide tool over the secondary shaft.
2.
If center distance is correct, the
tool notch will fit over drive
sheave hub.
3.
Alignment and 1.30" offset are
correct when the tabs are flush
with engine side of fixed face.
4.
Adding or removing shims on secondary shaft will change offset.
5.
If center distance or alignment is
incorrect, loosen four engine mounting bolts (located under eng in e base
plate) .
6.
Align engine to driven clutch.
7.
Tighten four mounting bolts.
8.
Remove tool.
Alignment tool JOM-81 will check three
dimensions.
1.
Center distance is 11.47".
2.
Sheave alignment and 1.30" offset is
checked a t tabs.
3.
Secondary shims are measured with
end of tool.
- 22 -