Download Envoy Lane Machine

To test the Oil Injectors on the lane:
1. Go to the Maintenance menu.
2. Select “Diagnostics” and press “OK”.
3. Use the up/down arrows to navigate to “Tests” and press “OK”.
4. Select the Oil Injector test, press “OK” and the following screen will appear (“Oil Injector” will
appear at the top of the screen for the injector test). Refer to Figure 5-32.
Figure 5-32. Oil Injectors
5. Press “OK” to prepare the machine for operation. This may require a pattern download.
6. Put the lane machine on the lane when the message appears.
7. Press “OK” to start the test.
NOTE: The machine will automatically clean approximately the first 25 feet of the bowling
lane and inject at the same time while performing this test. Perform a clean only or a clean and
condition after completion of the Oil Injector test.
Cleaner Spray Test
The test for the Cleaner spray is used to verify the cleaner coverage. This test allows the technician
to visually see how well the cleaning spray is covering the lane during a cleaning run. The process is
performed in two passes of the lane machine. The first pass of the machine will clean approximately
25 feet of the bowling lane. The second pass sprays cleaner to the bowling lane as it travels without
interference of the duster and the squeegee assembly. The cleaner will pulse about half way through the
second run. Cleaner spray pressure during this test should be between 17-19 psi.
90 Section 5: Using the GUI
Envoy Operation & Service Manual