Download AR-7EVH - Alto

SERVICE
ROTISSERIE, BULB REPLACEMENT INSTRUCTIONS
A
To Replace Bulbs:
A.
Remove four screws holding glass light
cover (CV-26607) and gasket (GS-26609)
in place, taking care to not let the glass
cover (GL-26608) fall into the oven.
B.
Pull bulb out.
C. Push replacement bulb (LP-34213) in place.
D. Re-install glass cover and gasket, securing
with four screws removed in step one.
B&C
CAUTION
DO NOT HANDLE NEW BULB WITH
BARE HANDS. WHITE COTTON
GLOVES SHOULD BE WORN WHEN
REPLACING BULBS.
D
CAUTION
The performance of this unit has
been optimized using the factory
provided bulbs. These bulbs should
be replaced with an exact replacement
or with a factory recommended
replacement. These bulbs have been
treated to resist breakage and must be
replaced with similarly treated bulbs in
order to maintain compliance with NSF
standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb filament.
P art numbe rs a nd dra wings ar e s ubjec t t o c hange w i t h o u t n o t i c e .
M N- 28907 ( R e v 0 ) • A R -7 E VH El e c tri c R oti sseri e w i th V entl ess H ood Operati on & C are Manu al • 31