1
Download KINROAD
Transcript
KINROAD 150 SERVICE MANUAL VERSION 1, DEC., 2005 Clean the carbon around the spark plug to prevent it from dropping into the cylinder when removing the spark plug. Remove the spark plug. When installing, connect the black/yellow wire of the primary ignition coil with the black/yellow connector of CDI, and the green wire with the green connector of CDI. Clean the filth and carbon accumulation on the spark plug with a steel brush or a blade. Inspect the spark plug gap. In general it should be about 0.6 - 0.7mm. When the carbon accumulation and wear of the spark plug are too much, replace the spark plug. Replace with the spark plug of the same specification 73
