Download service manual 16-17

16-26 ELECTRICAL SYSTEM
Charging System
Alternator Rotor Installation
• Clean [A] the inside of the rotor and the end of the crankshaft.
• Fit the rotor onto the crankshaft so that woodruff key [B]
fits in the groove [C] in the hub of the rotor.
• Install the torque limiter [A] .
• Install the alternator rotor [B] while turning the starter
clutch gear [C] .
Alternator Stator Removal
• Remove :
Alternator Cover (see Alternator Cover Removal)
Crankshaft Sensor [A] (see Crankshaft Sensor Removal)
Bolts [B] and Alternator Stator [C]
Alternator Stator Installation
• Tighten :
Torque -Alternator Stator Bolts : 13 N-m (1 .3 kgf-m, 113
i n . l b)
• Install :
Crankshaft Sensor (see Crankshaft Sensor Installation)
• Fit the lead grommets into the notch on the alternator
cover.
Grommets [A] for Alternator Leads
Grommets [B] for Crankshaft Sensor Leads