Download General Information - Techinfo

Table of Contents
Installation
4. Clamp the side sill reinforcement complete (A) on the
body. Install the center pillar inner separator (B) and
the rear wheel arch separator (C).
NOTE:
● Welding symbols
: 2-Plate spot welding
: 3-Plate spot welding
: 4-Plate spot welding
: MAG plug welding
: MAG welding
L=Welding length unit: mm (in)
● ( ): The number of welds
1. Clamp the new center inner pillar.
2. Install the new front pillar inner and outer separators
to the front pillar lower stiffener (see step 2 on page
3-22).
3. Apply the sealer (A) without gaps all the way around
the front pillar inner separator (B) and the inner lower
pillar (C).
A
B
C
5. Remove the center pillar stiffener from the new center
pillar stiffener complete.
6. Grind away the upper edge [X] position of the new
center pillar stiffener (A) as shown.
C
[X]
B
A
A
(cont'd)
3-33