Download Operating Manual

settling at the bottom of the kettle where they can damage the
chromoxide layer, exposing the steel to corrosion.
Switching the kettle on and off
Turn kettle power supply on by turning the handle clockwise to
position ‘I’.
Turn off by turning the handle anticlockwise to position ‘0’.
Power on
Power off
The kettle’s controller is switched on by pressing
off by pressing .
and switched
Entering an access code (AutoTemp 31, 35, 51 and 55 only)
If a requirement for an access code has been activated in the user
menu in order to switch the kettle on, the heating display will show
‘PAS’, and a four digit access code must be entered in order to
activate the kettle.
The code will be shown in the water display and is set using the
arrow keys. The large arrows alter the code by 100 and the small
arrows alter the code by 1.
When the access code has been selected, press water- .
If the code is correct, the kettle will be activated. If it is incorrect,
error code U01 will be shown for three seconds, after which another
attempt can be made.
Operating the tilting function
When the kettle’s tilting function is used, no one may be present
immediately below or behind the kettle due to the risk of
crushing injuries.
Page 14/66
Document 10000003869-000-02 EN