Download Operating Manual

Timer (AutoTemp 31 and 35 only)
The Timer function is controlled using the part of the panel shown in
the following illustration. The first two digits in the display show
hours and the last two digits show minutes.
Key for
timer signal
Display for
remaining time/time
LED for
timer on
Key for time signal
The Timer function enables the heating/chilling function to be
switched off either at a particular time or after a remaining period of
time. The beeper and display are also activated and the LED will
flash.
The signal lasts for ten seconds, but can be stopped by pressing
either or .
If the Timer function is not active, the current time will be shown on
the display.
The Timer is activated automatically if a time or remaining time is
set. The LED will illuminate when the function is activated.
The Timer is deactivated by holding down or for three seconds.
Setting the time for the signal
Press so that the display and LED flash slowly. Set the required
time using the arrow keys.
If the Timer function is active, the current signal time will be shown.
The function will be exited automatically after three seconds without
a key press or if another function is selected.
Setting the remaining time before the signal
Press so that the display and LED flash slowly. Set the required
time using the arrow keys.
If the Timer function is active, the current remaining time will be
shown.
The function will be exited automatically after three seconds without
a key press or if another function is selected.
Page 29/66
Document 10000003869-000-02 EN