Download PDF Manual

19.
MOTOR DIRECTION TEST
Use the UP ARROW
Does the gauge move back?
YES or NO?
If the backgauge moved toward the rear of the cutter,
press “YES.” If it moved toward the front, press
“NO.”
<
The computer will automatically orient the
motor polarity as necessary.
OR
YES
20.
21.
<
NO
Calibration routine!
Please wait !!!
Move the handwheel
To an even value --This position is .000 inches
EXACTLY
The backgauge will now move toward the rear of the
machine to trip the Rear Position Sensor.
<
It is imperative that the position sensor is
adjusted properly so the gauge will stop
before hitting the rear of the machine. (See
MECHANICAL
INSTALLATION,
Proximity Sensors.)
<
If the backgauge bumps into the rear, press
any key to return to the beginning of the
START UP ROUTINE. Check the LED
indicator on the position sensor and adjust as
needed, and begin the SET UP ROUTINE
over again.
Turn the handwheel forward until the backgauge is at
an exact unit value. Type the exact current position
and then press “YES”.
<
microcut uses the reference positions to
calculate the leadscrew pitch and calibration
values. These positions must be as accurate
as possible or microcut will not be able to
position the backgauge accurately.
<
microcut requires that these values be whole
numbers, with no fractional component. Use
the handwheel to position the gauge
accurately before entering the value.
When turning the handwheel to move the backgauge to an exact unit value (inch, cm, mm, or
sun), do not ever turn the handwheel backwards. If the exact unit value is missed, do not
turn the handwheel backwards. Simply continue forward until the next exact unit value is
reached. This will prevent backlash from entering the measurement.
39