Download PDF Manual

position within the programmed settling
tolerance.
<
A “NO” here will cause the computer to display the backgauge position as “perfect” when it
has settled on a mark in AUTOMATIC MODE, as long as it is within the tolerance
programmed in step 37.
YES
40.
11.753” or 11.75”
Do you want to see
The final digit?
YES or NO?
Select the number of digits to be displayed to the
right of the decimal point.
<
Choose “YES” if microcut is to display
thousandths (3 digits after the decimal point)
or “NO” if only hundredths are desired (2
digits after the decimal point).
YES
41.
Do you want the
UNITS key to select
The inch display?
YES or NO?
Should the “UNITS” key be able to select inches?
YES
42.
Do you want the
UNITS key to select the
fractional display?
YES or NO?
Should the “UNITS” key be able to select oldfashioned cutter’s fractions?
48