Download MAINTENANCE INTERVALS - Safety

SEBU8417-01
Illustration 230
201
Maintenance Section
Hydraulic Oil Filter - Replace
g02002673
The brake cooling oil filter is located on the outside frame rail
behind the right front suspension cylinder.
2. Remove the drain plug from end cap (1). Drain the
oil into a suitable container.
3. Inspect the seal for the drain plug. Replace a
damaged seal with a new seal. Wash the drain
plug in clean nonflammable solvent and install the
drain plug.
4. Remove the end cap from the filter housing.
5. Remove the filter element. Properly discard the
used filter element.
6. Inspect the seal for the end cap. Replace a
damaged seal with a new seal. Wash the end cap
in clean nonflammable solvent.
7. Install the new filter element. Install the end cap
on the filter housing.
Illustration 231
g02002693
8. If the machine is equipped with the additional
retarding (configuration) perform the
following: Repeat steps 2 through 8 for filter (2)
that is located on the outside frame rail behind the
left front suspension cylinder.
9. Start the engine and operate the engine at an idle
for five minutes. Inspect the oil filter(s) for leaks.
Make any necessary repairs.
10. Check the oil level in the hoist/brake tank. If
necessary, add oil. For the proper procedure, refer
to Operation and Maintenance Manual, “Hydraulic
Tank Oil Level - Check (Hoist and Brake System)”.