Download SERVICE MANUAL/INTEGRATION SPLIT TYPE

No.
Photo / Explanatory diagram
Procedure
Rework the side cabinet (L) to remove part of it.
Side cabinet (L)
The area to be removed is indicated by the shaded
lines in the left figure.
After removing part of the side cabinet (L), deburr the
edges of the side cabinet (L).
2-4
Delete
Perform end process and bundling of each cable.
Close-end connector
insulation tape
Using fixing screws (Self-tapping screw type-B Ø3.5
× 6mm), fix the thermostat to the thermostat fixing
plate.
Thermostat
Power cord
Perform end process for various lead cables and
connect them according to the wiring diagram.
Attach #250 Faston and UL-approved sleeves each
to the end of lead cables which are connected to the
thermostat.
2-5
Thermostat
fixing plate
Cord heater
* Transparent
L side
P-shape clamp
Fuse
Fuse holder
Using insulation tape, apply protective measures to
the connected parts by the close-end connectors.
Using P-shape clamp and the screws (Self-tapping
screw type-B Ø4 × 8mm), fix the power cord to the
thermostat fixing plate.
When the power cord size does not match with Pshape clamp, procure the most appropriate one at
the local site.
– 190 –