1
Download WASHER/DRYER COMBO TRAINING MANUAL
Transcript
COMBO MAIN PWB 1. Disconnect the POWER connector and the SENSOR SWITCH assembly. 2. Remove the protective cover by lifting the plastic clips around the top and sides. 3. Disconnect all the connectors. Note that they are all different shapes and colors to prevent any mistakes upon replacement. (See photo, page 57.) WM3677 COMBO 4. Remove the screw on the back. 5. Remove the MAIN PWB from the COMBO. Slide it to the right and then lift. 6. Reassembly is the reverse of these steps. Page 36 of 68 TRAINING MANUAL
