Download OptiMelt Automated Melting Point System

Transcript
OptiMelt Remote Programming
95
Appendix D
OptiMelt Remote Programming
Using USB
Introduction
Remote programming of the OptiMelt using USB requires:
•
An OS that supports USB (Windows 2000, XP, 98, Mac OS 8/9 or OS X).
•
Application software (MeltView from SRS, your own Labview, C++, etc. program or
a terminal emulator such as HyperTerm) that can access a COM/serial port.
•
A USB driver for your OS.
•
USB hardware on your computer.
•
A USB cable.
Virtual Com Port Driver
The OptiMelt USB port is based on the FT245BM chip from FTDI (www.ftdichip.com).
FTDI supplies a Virtual COM Port (VCP) driver for Windows and Mac OS. Once
installed, the VCP driver makes the OptiMelt appear as if it were connected via a normal
COM port (serial port). Program control is possible using any program capable of
communicating with a COM/serial port. The COM/serial port’s baud rate, start, stop, and
parity are ignored by the VCP.
Windows XP, 2000/98
FTDI's Virtual COM Port (VCP) Drivers appear to the system as an extra Com Port (in
addition to any existing hardware Com Ports). Application software accesses the USB
device in the same way as it would access a standard Windows Com Port using the
Windows VCOMM API calls or by using a Com Port Library. This driver is Windows
XP certified and will be installed automatically (may require an internet connection).
Quick Start
•
Plug the OptiMelt into a PC USB port and turn the unit on. Windows will display the
message “Found New Hardware USB <-> Serial”.
•
If the driver is already available on the computer then it will be installed and a few
seconds later “Your new hardware is installed and ready to use” will be displayed.
OptiMelt Automated Melting Point System