Download Workshop Manual

Repair Instructions
4
7
Remove the oil pump, together with the main bearing.
Oil and install the main bearing shell in the cap.
Remove the bearing shell from the cap.
8
Lift the oil pump into place, install and tighten the
bearing cap screws.
5
Torque the screws to 150 Nm (15 kpm.
9
Remove the bearing cap from the oil pump bracket.
Install the oil supply pipe on the pump and the cylinder block.
Tighten the unions by hand.
Installation
Note! If you re-install the old supply pipe, check the
ends of the pipe for cracks.
6
10
Tighten the unions on the pump and the cylinder
block until they bottom.
11
Mark the unions with a felt-tip pen.
Note! Permanent marking must not be used.
Screw the bearing cap to the oil pump bracket.
Torque the screws (65 Nm (6.5 kpm) and lock with
the lock tabs.
19