Download IBM 4610 SureMark Printer Manual
Transcript
Updated April 2, 2009 where: n1 The high-order byte of the dot offset from the beginning of the print line. n2 The low-order byte of the dot offset from the beginning of the print line. Default: n1 = 0, n2 = 0 Remarks: In the customer receipt station, 1 mm = 8 dots. In the document station, 1 inch = 150 half-dots (75 dots). n1 and n2 are hex values. Convert each to decimal. Then, use this formula to get the decimal equivalent: (n1 × 256) + n2. If the number exceeds the printable area, it is ignored. The maximum value for the customer receipt station is 576. The maximum value for the document insert station is 474. In the customer receipt station, this number is rounded back to a factor of 8. This command should be sent after “Set print station parameters” on page 136. Set relative position EIA-232 Syntax: ESC <5C>h n1 n2 or X'1B5C;n1;n2' where: n1 The high-order byte of the dot offset from the left margin. n2 The low-order byte of the dot offset from the left margin. Default: n1 = 0, n2 = 0 Remarks: In the thermal station, 1 mm = 8 dots. In the impact station, 1 in. = 75-dots (150 half-dots). n1 and n2 are hex values. Convert each to decimal, then use this formula to get the decimal equivalent: (n2 × 256) + n1 To move the position to the left, use a negative number. Example: To move N dots to the left⇒ 65536 − N. If this number plus the left margin exceeds the printable area it is ignored. See “Set left margin position” on page 138. In the customer receipt station, this number is rounded back to a factor of 8. Align positions EIA-232 Syntax: ESC a n or X'1B61;n' Appendix D. EIA-232 programming information 139