Download A290 L2 Service Manual
Transcript
A290 L2 Service Manual 1. Technical Specifications Particular Remarks Key Matrix For Flashing Chipset Android Version Frequency NA MT6592M Android 4.4.2 1.4GHz 900MHz/1800MHz/1900MHz/850MHz WCDMA 900MHZ/2100 MHz 8G 1G 5.64G (share with data memory) 32G Press vol+/ Vol-/ power key at the same time 32Ω ± 15% 8Ω ± 5% 2.2kΩ ± 5% 30Ω ± 5% Network Mode ROM RAM Internal SD Card memory Expandable Memory Factory mode code Good Earpiece volume Good Loudspeaker volume Good Mic volume Good Vibrator volume A290 L2 Service Manual 2: CAUTIONS I. Flashing & Servicing must be undertaken by qualified personnel only. II. Ensure all work is carried out at an anti-static workstation and that an anti-static wrist strap is worn. III. Use only approved Tools & components as specified in the parts list. IV. Ensure all components, modules, screws, and insulators are correctly re-fitted after servicing and alignment V. Ensure all cables and wires are repositioned correctly if Handset disassembled VI. Electrostatic discharge can easily damage the sensitive components of electronic products. Therefore, Service Centre must adhere the precautions which mentioned above. 3:Service Details Main Components Vibrator connector Battery LCD connector Camera connector TP connector SPK RF coaxial line Main FPC Battery connector Earphone Connector A290 L2 Service Manual 1. Does not power on S.NO 1 2 Possible Cause NO power on Battery capacity level is too low Validation steps Power on key is fail Action Change keys Battery capacity Charging the tablet Sw issue PCBA faulty Flash the handset with latest SW Replace PCBA / Refer L3 Repair A290 L2 Service Manual 2. Display issue/No display S.NO 1 2 3 Possible Cause No display Colored screen Dark screen Validation steps Action Sw issue Flash the handset with latest SW LCD fail Change LCD PCBA fail Change PCBA LCD fail Change LCD LCD fail Change LCD Sw issue Flash the handset with latest SW LCD backlight circuit issue Change PCBA LCD backlight is set too low by person Reset the value of backlight A290 L2 Service Manual 3. Touch panel S.NO 1 2 Possible Cause TP not working TP not working proper Validation steps SW Issue TP issue TP connection issue PCBA issue TP issue PCBA issue Action Flash the handset with latest SW Charge TP Assemble TP again Refer to L3 repair Charge TP Refer to L3 repair A290 L2 Service Manual 4. Proximity Sensor S.NO 1 Possible Cause Proximity sensor fail Validation steps SW Issue Sensor holder is not assembled well PCBA issue Sensor Action Flash the handset with latest SW Re-assemble the sensor holder Change PCBA A290 L2 Service Manual 5. G-sensor S.NO 1 Possible Cause G-sensor is not working Validation steps SW Issue Set problem PCBA issue Action Flash the handset with latest SW Reset mobile Change PCBA Validation steps Key is fail Key is fail Key is not assembled well Action Change Keys FPC Change Keys FPC Re-assemble 6. Keys S.NO 1 2 Possible Cause Key is not response The feeling of pressing key is bad A290 7. L2 Service Manual Charging S.NO 1 2 Possible Cause Cannot charge into Have charging icon, but not charged Validation steps Adapter is fail Action Change adapter SW Issue Flash the handset with latest SW PCBA fail Battery fail Battery connector issue Change PCBA Change battery Change battery connector Battery connector A290 8. L2 Service Manual USB S.NO 1 Possible Cause Cannot connect to PC Validation steps USB cable is fail Main FPC fail PCBA fail Action Change USB cable Change Main FPC having I/O connector Change PCBA I/O connector A290 9. L2 Service Manual Front Camera S.NO Possible Cause Validation steps Action 1 Colored screen when open front camera Camera is fail Change camera PCBA fail Change PCBA Sw issue Flash the handset with latest SW 2 Cannot turn on front camera Camera fail Change camera PCBA fail Change PCBA Possible Cause Validation steps Action 1 Colored screen when open front camera Camera is fail Change camera PCBA fail Change PCBA Sw issue Flash the handset with latest SW 2 Cannot turn on front camera Camera fail Change camera PCBA fail Change PCBA 10. Rear Camera S.NO A290 L2 Service Manual 11. Playing Video S.NO 1 Possible Cause Hang often Validation steps Sw issue CPU poor soldering DDR poor soldering Action Flash the handset with latest SW Refer L3 Repair Refer L3 Repair DDR CPU A290 L2 Service Manual 12. Vibrator S.NO Possible Cause 1 Vibrating is not properly 2 NO vibrate 3 Vibrate weakly Validation steps Vibrate assemble issue Vibrate issue Soldering issue Vibrate issue PCBA issue Vibrate issue Action Re assemble Change it Re soldering it Change it Refer to L3 service Change it Vibrator Pads 13. WiFi S.NO 1 Possible Cause WI-FI not working Wifi antenna Validation steps Set wifi turn off as default 4 in 1 chip fail Action Reset wifi to turn on wifi Change PCBA WIFI chip A290 L2 Service Manual 14. RF Network S.NO 1 Possible Cause RF Network cannot searchable Validation steps RF antenna is fail SIM socket is fail PCBA fail Action Change RF antenna Change SIM socket Change PCBA SIM connector Antenna RF PA 15. Bluetooth / FM S.NO 1 Possible Cause Cannot turn on BT / FM Validation steps Sw issue PCBA fail BT antenna fail 4 in 1 chip issue Action Flash the handset with latest SW Change PCBA Change antenna Change 4 in 1 chip 4 in 1 chip Antenna A290 L2 Service Manual 16. Receiver S.NO Possible Cause 1 Noise/crack 2 Noise/volume low Validation steps Dust with receiver Receiver issue Connection issue Receiver issue Action Clean it Change it Assemble it Change it 17. Earphone S.NO 1 Possible Cause Not working / from earphone Validation steps Action Earphone not detecting Change earphone connector Earphone connector having poor soldering Change earphone connector Earphone connector A290 18. L2 Service Manual MIC S.NO Possible Cause 1 Noise with uplink side 2 Volume low 3 No recording Validation steps Some dust with mic MIC issue PCBA issue soldering issue PCBA issue MIC issue SW issue PCBA issue Action Clean it Change Main FPC Refer to L3 repair Change Main FPC Refer to L3 repair Change Main FPC Re-install SW Refer to L3 repair MIC A290 19. Speaker S.NO 20. L2 Service Manual Possible Cause 1 Noise/crack 2 No volume 3 Low volume Validation steps Speaker with dust Speaker foam issue Speaker issue Assemble issue Speaker issue Audio PA issue Assemble issue Speaker issue Audio PA issue Action Change speaker Change speaker Change speaker Assemble again Change it Refer to L3 repair Assemble again Change it Refer to L3 repair Validation steps Sw issue GPS antenna issue 4 in chip issue Action Flash the handset with latest SW Change GPS antenna Change PCBA GPS S.NO 1 Possible Cause GPS not connecting 4 in 1 chip Antenna A290 21. L2 Service Manual Battery S.NO Possible Cause 1 Show charging but it is not charged 2 No charging 3 Cannot charge fully Validation steps Battery issue Charging connector issue Charging IC issue Battery issue Charging IC issue battery connector issue Action Change battery Change PCBA Change PCBA Change battery Change PCBA Change battery connector Battery connector Thanks For any Query or suggestion, Please write to [email protected]