Download Technical Service Guide

Transcript
Flame Detector
Ignitor
The flame detector is attached to the right side of
the combustion chamber.
WARNING: Sharp edges may be exposed when
servicing the dryer. Use caution to avoid injury.
Wear Kevlar gloves or equivalent protection.
To remove the flame detector:
The ignitor is located at the end of the burner
assembly in the combustion chamber opening and
has a maximum rating of 4 amps. The ignitor has an
approximate resistance value of 300 to 500 Ω.
The ignitor is attached to the gas valve bracket
with a Phillips-head screw. To access the ignitor, it is
necessary to remove the burner assembly. (See Gas
Valve , steps 1 through 7.)
1. Remove the drum. (See Drum.)
2. Disconnect the 2 wires from the flame detector.
3. Remove the Phillips-head screw that holds the
flame detector to the combustion chamber.
Gas Valve Bracket
Caution: The ignitor is very fragile. To prevent
breaking the ignitor, care must be taken when
installing the burner assembly.
4. Remove the flame detector from the tab at the
bottom.
Note: Upon reassembly, ensure the tab at the
bottom of the flame detector is inserted into the slot
located on the combustion chamber.
– 48 –