Download Finesse E+ and ME+ Operator Guide

Transcript
Note
1
2
The ‘ROCK’ and ‘RETRACT’ facilities cannot be used at the same time.
When ‘WAX’ is selected as the chosen medium, the status of ‘ROCK’ and ‘RETRACT’
can be different for ‘TRIM’ and ‘SECTION’.
To enable the rock facility, the rock position must be saved.
Turn the Handwheel to move the specimen to the start, or
top, of the cutting sector (a).
Press [ROCK] on the Control Unit to save the start of the
rocking sector (b). The green LED lights when the facility is
selected (e).
a
ROCK
Move the Handwheel so that the specimen passes across the
knife and then back up again (c).
b
ROCK
When the specimen is above the set rock position, the
amber LED on the button (d) lights. The Specimen Head
advances by the set distance.
ROCK
c
Note
1
d
If a Cutting Sector has previously been set, the
Finesse will use the existing top position when
[ROCK] is pressed.
e
To cancel the rock facility, press [ROCK] again.
4.7
TO USE THE MEMORY
To help reposition similar sized specimens, press [MEMORY] on the Control Unit when
the Specimen Head has advanced to the required position to start to trim. The
green LED is lit to indicate that a position is saved.
MEMORY
AUTO
If [AUTO] is then pressed, the Specimen Head rewinds a set distance back from the knife
so that the specimen cassette can be removed. (The distance can be set in the Auto Load
Options Menu section of User Setup, described in Appendix A, section A.3.6).
A77510300GB Issue 3
51