Download Service manual

Permobil X850
Repairs
Seat lift motor
Removal
1. Place the wheelchair on a level surface. Raise the
seat to the highest position. If the seat lift does not
work normally because the batteries are discharged
or the motor is defective, see page 22.
2. Switch off the power supply using the ON/OFF key on
the control panel and switch the automatic main fuse
to Off. It is accessible via a recess on the chassis.
See page 36.
3. Remove the chassis covers. See page 7.
4. Remove the seat lift motor’s cabling from the connection box. See the illustration.
5. Unscrew and remove the two screws that hold the
motor in place at the very rear of the seat lift. See the
illustration. Pull the motor straight backwards.
L
Figure 41. The seat lift motor’s electrical connection.
WARNING!
The seat lift motor must not be operated unless the
motor is properly screwed to the seat lift. Otherwise
there is a risk of damage to materials.
Assembly
Install in the reverse order.
Figure 42. The seat lift motor is held in place with two
screws.
Figure 43. Seat lift motor.
33