Download Electronics and HWH

Transcript
RELAY
CONTACTS
(NO)
RELAY
COIL
M
Fig. 3
We use relays for many different purposes. We use them to switch large amounts of current that a manual
switch or a computer processor will not handle. They are used to send information to computer processors from
limit switches or warning switches. They can also be used as a safety switch to interrupt a process that is
reaching a critical condition that could create a system or component failure. Many of the relays we use are pc
board mounted and are not field serviceable. The main relays we use that are serviceable are on the hydraulic
pump motors and on our air compressor assemblies. There are two different types of relays used on the
hydraulic pump motors, a continuous duty and an intermittent duty relay. The continuous duty relay is only
used with automatic, computerized systems. This relay is called the master relay. Systems that do not use a
hydraulic pump may have a master relay. It may be mounted in a control box or remote from the control box.
System diagrams or schematics will supply this information. The intermittent duty relay is called the pump
relay and is used with any system that has a hydraulic pump motor. The relay used on air compressor
assemblies is a continuous duty relay. All three of these relays have normally open contacts. The coil of all
pump and air compressor relays is controlled with a + signal except for the pump relay on 400 series leveling
systems and 200 series Joystick leveling systems. A switched ground controls these relays. Safety and other
relays may be controlled by either a + voltage or ground signal. You should always check system diagrams
and/or schematics to determine the control signal for a relay.
We use a small Bosch relay as a safety switch with all four cylinder and other pressure sensitive room extension
mechanisms. This relay is normally mounted on the pump motor. The Bosch relay can be wired as a normally
open or normally closed relay. Check specific system wiring diagrams for use and orientation of the relay
contacts.
2-3.1 Relay diagnostics. Before doing the actual diagnostics, it is important to know a few things about the
relay and the circuit it is in. Are you switching + voltage or ground? Is the relay a normally open or normally
closed relay? Is the relay coil controlled with a switched + voltage or a ground?
Most of the relays we use draw less than 1 or 2 amps so operating a relay does not create much of a load, a test
light will usually do most of the diagnostics needed or at least give you the basic answers to the tests for relay
diagnostics. When helping someone diagnose a relay problem, one statement I frequently get is; “my test light
will come on when I touch either of the coil terminals”. You need to remember that a coil is just one long wire
wrapped around a metal rod. If there is + voltage on both relay coil terminals there is no ground for the
coil. If there is a ground on both relay coil terminals, there is no + voltage to the coil of the relay.
+12
VOLTS
GND
+12 VOLTS
COIL
COIL
GND
+12
VOLTS
Fig. 4
4
+12 VOLTS