Download Basic Pinspotter Instruction

TABLE SPRINGS
(Yoke Shaft)
Springs are used on the yoke shafts to stabilize cup movement in a spotting cycle, Occasionally a pin
may become jammed between the yoke and the table. This may hold the spotting cups in a vertical
position when the table comes up. When this occurs the table should be cranked down to relieve some
tension, and to gain clearance between the yoke and the bins. The cups can than be turned more
vertical to free the jammed pin. When the pin has been freed, the cups can be allowed to turn back to
a horizontal position. Care must be used here as there is considerable spring tension on the spotting
cups. The table should be returned to its zero position.
30