Download english

Transcript
OPERATION INSTRUMENTS »
Hand brake lever
The hand brake lever [1] is mounted on the handlebar on the right and actuates the front wheel brake.The adjusting screw [B] is used to change the original position of the hand brake lever (see maintenance work on chassis and
engine).
1
B
Choke lever
ENGLISH
If the choke lever [2] is pulled backwards, a bore will be opened in the carburetor through which the engine may draw in additional fuel. This produces
a „rich“ fuel/air mixture necessary for cold start. If the choke lever is pushed
forward up to the stop, the bore will be closed again. In this position the choke
cable must have a play of approx. 2 mm.
2
6
Ignition lock
Switch positions of ignition lock
Ignition off, (engine can't be started)
Ignition on, (engine can be started)
Ignition off, handlebar blocked
To switch the ignition to position
turn the ignition key to position
and
firmly press it into the lock. Turn the handlebar to the left, then turn the ignition key to the left.
The ignition key can be withdrawn in position
and .
Socket for electric accessories
A socket is provided in the cockpit for electric accessories, e.g. GPS, roadbook, cell phone, etc.
The socket has a 12V voltage and is protected by a 5 A fuse. Do not plug
power consumers with a higher requirement into this socket.
You can also use this socket to charge the battery with a maximum of 14.4
volts and 4 amperes.
+
–
– REMEMBER THAT ELECTRIC ACCESSORIES WILL RUN DOWN THE BATTERY.
– THE DIGITAL SPEEDOMETER CAN BE DESTROYED IF THE ABOVE CHARGING
LIMITS ARE EXCEEDED.