Download Operator and Service Manual

10295-D01-00
Page 24 of 126
Test Smoke / Heat Alarms
Test all smoke / heat detectors in turn observing correct operation of all alarms. Use the
test button on each smoke / heat detector. Keep a detector in fire by continuing to press
the test switch or use a recommended smoke test match or “Canned Smoke” spry. Each
test will result in all interconnected detectors sounding an alarm and the following:
1. General Fire Indicator illuminates and all alarms sound.
2. Press (*) Access (2) (1) (3)
3. Access LED Illuminates
4. Press (1) Silence / Mute / Locate – All smoke / heat alarms except the initiating
alarm will silence.
5. Release the test button or clear the smoke from the detector – The detector will
automatically reset.
6. Press (2) Reset / Test Lamps Button – The panel internal buzzer silences and the
General Fire LED extinguishes.
Test Call Points
Test all call points using the key provided.
1. Red call point operated LED illuminates. All interconnected smoke / heat detector
alarms sound.
2. Press (*) Access (2) (1) (3)
3. Access LED Illuminates
4. Press (1) Silence / Mute / Locate – All smoke / heat alarms except the initiating
alarm will silence.
5. Release the test button or clear the smoke from the detector – The detector will
automatically reset.
6. Press (2) Reset / Test Lamps Button – The panel internal buzzer silences and the
General Fire LED extinguishes.
The information contained in this booklet is the property of OSV. The contents are confidential. They may not be used,
either partially or wholly, for any purpose inconsistent with the purpose for which it was produced. The contents may not be
reproduced or disclosed without written permission of Oshkosh Specialty Vehicles.