Download Operator and Service Manual

10295-D01-00
Page 87 of 126
Storing the Hydraulic Lift for Transport of the Mobile Unit
After the stair assembly has been removed, the hydraulic lift can be stored for transport.
1. Lower the hydraulic platform lift to the ground.
2. Remove the restraining hardware and handrails and temporarily place them to the
side.
3. Raise the lift to a maximum height and fold the lift upwards to a vertical position. A
torsion bar is located within the hydraulic platform lift hardware that will enable one
person to move the lift into the transport position.
4. Lower the lift so that it rests securely in the retaining cradles. Make sure that the
micro switch is actuated.
5. Insert the transport pins into their transport positions. Make sure that the micro
switches are actuated.
6. Connect the Lift Transport Restraining Cable securely in place.
7. Remove the remote control pendent from the socket and lock the access door to
the hydraulic platform lift controls.
8. Open the underbody compartment door and store the remote control pendent and
handrail assembly in the underbody storage compartment.
The information contained in this booklet is the property of OSV. The contents are confidential. They may not be used,
either partially or wholly, for any purpose inconsistent with the purpose for which it was produced. The contents may not be
reproduced or disclosed without written permission of Oshkosh Specialty Vehicles.