Download www.silverlinetools.com PDF Compressor Pro
Transcript
PDF Compressor Pro GB Troubleshooting Fault Machine does not start No hammering action The machine does not operate at full power Oil is leaking from the machine housing 8 Possible Cause Solution Interruption in the power supply Check the power supply; ensure the plug is switched on. Have the power circuit tested by a qualified electrician The power cable or mains plug is defective Have the power cable replaced by an authorised Silverline service centre The on/off trigger switch is defective Have the switch replaced by an authorised Silverline service centre Construction site generator in sleep mode Activate generator Voltage from generator too low or incompatible with this machine This machine may be incompatible with this specific power source The machine is too cold Have the machine warm up, then run it under no load to warm up the oil and loosen up the internal mechanisms Insufficient lubrication Check oil level (see ‘Maintenance’) and top up if appropriate. Running the tool with insufficient lubrication may have caused tool damage, in which case the machine needs to be repaired by an authorised Silverline service centre A fault has occurred in the machine Have the tool repaired by an authorised Silverline service centre The extension lead is too long or of inadequate cross section Use a suitable extension lead The voltage provided by the power supply is too low Check power supply and change to a different circuit if possible A fault has occurred in the machine Have the tool repaired by an authorised Silverline service centre Seals missing/damaged If occurring after an oil service or top-up, check the seals underneath the covers that had been removed during service. Otherwise, have the tool repaired by an authorised Silverline service centre