Download OSMOSE COMPACT 130
Transcript
Water hardness soft Total hardness Rinsing intervals less than 7 °d 15 minutes every 3 weeks medium 7 - 14 °d 15 minutes every 2 weeks hard 14 - 21 °d 15 minutes every week very hard above 21 °d 5-10 min every time after operation • After rinsing reinsert the flow restrictor. 8 Replacing the membrane If used properly, the modern Dennerle polyamide/polysulphone membrane will have a service life of 3-8 years. The service life depends in particular on the quality of the tap water, the operating conditions, the intensity of usage, mem brane care by means of regular rinsing as well as the timely replacement of the pre-filter. The membrane should be replaced if (1) the conductivity or hardness of the osmosis water is greater than 25 % of the tap water, or (2) the produced osmosis water drops to below 70% of the original amount, despite otherwise correct use (tempera ture, pressure, filter not blocked). Before measuring these values, the device should have been rinsed for 15 minutes and have been in operation for at least 2 hours. Replacing the membrane: • Turn off the tap. D • Unscrew the coupling ring from the angle fitting on the membrane container lid and extract the hose from the fitting. • Unscrew the membrane container lid using the spanner provided (D). Carefully remove the membrane using a pair of pliers. • Lightly grease the two O-ring seals on the new osmosis membrane with Vaseline (chemist). Insert the membrane (the two O-rings first) into the membrane container as far as it will go (E). • Likewise, lightly grease the O-ring for the membrane container lid with Vaseline. Screw on the container lid tightly and reconnect the hose with the hose insert. Please E note the general tips on fittings (see section 10)! • Turn on the tap and check that the device is watertight. •Allow the new membrane to run for 2 hours. During this period, DO NOT use the osmosis water. Then rinse the system for 15 min. as described under point 7 – Maintenance. 9 Replacing the fine filter or active carbon filter 9.1 Fine filter You will notice whether the fine filter is blocked if the flow rate declines significantly. Check fine filter: • Release the hose screws on the membrane container lid. • Turn on the tap and measure the volume of water flowing out of the outlet of the fine filter: Replace the fine filter if the volume is less than 1 l/min. • The fine filter should generally be replaced once per year; more often in case of poor water quality. 9.2 Active carbon filter • The active carbon filter should be replaced once per year, in case of heavily chlorinated tap water (smells of chlorine!) every 6 months. 19