Download UEP 48

ITALIAN TECHNOLOGY
Name
Special
grifo®
Shortcut
Function
<Alt+S>
Specific operations that may vary depending on the component
selected.
Load
<F3>
Analysis file format and loads the data from specified file to the
buffer. You can choose the format desired (Binary,
MOTOROLA, MOS Technology, ASCII space, Tektronix and
Intel (Extended) HEX). The control program stores a last valid
mask for file listing. You can save the mask into the config. file
by command Options / Save options.
Save
<F2>
Saves data in the buffer which has been created, modified, or
read from a device into a specified file. You can choose the
format desired (Binary, MOTOROLA, MOS Technology,
Tektronix and Intel (Extended) HEX).
FILE MENU
Load e.table
Load security table from disk.
Save e.table
Save security table to disk.
BUFFER MENU
View/Edit
<F4>
Fill block
This command is used to view (view mode) or edit (edit mode)
data in buffer (for viewing in DUMP mode only). Use arrow
keys to select the object to edit. Edited data are significed by
color.
Selecting this command fills the selected block of buffer with
requested hex (or ASCII) string. Set start and end block for
filling and requested hex or ASCII string.
Random buffer <Shift+Ctrl+F2> If this command is selected, the content of the buffer will be
filled with random data.
Copy block
This command is used to copy specified block of data in
current buffer on new address. Target address needn’t to be out
from source block addresses. See also Move block.
Move block
This command is used to move specified block of data in
current buffer to new address. Target address needn’t to be out
from source block addresses. Source address block (or part) will
be filled by topical blank character. See also Copy block.
UEP 48
Rel. 3.10
Page 61