Download UEP 50 ( IT

Transcript
grifo®
ITALIAN TECHNOLOGY
Programmer | Selftest ISP Connector...
Command executes a selftest of current programmer ISP connector using a specific diagnostic
POD. Before the user supply this command he must execute the other two selftest commands and
then he must follow the instructions of on line help.
Programmer | Calibration test...
Executes a test of calibration on many internal components and on used voltages.
OPTIONS
This menu let you view and change various default settings and operating modalities.
Options | General options...
General options dialog allows user to control following options of program.
File options
File options page allows you to set file masks, auto-reload of current file and choose file format
recognizing for loaded files.
File format masks is used for setting file-name masks to use as a filter for file listing in File
| Save and File | Load file window for all file formats. Mask must contain one of wildcards (*,
?) at least and must be applied correctly by syntax.
Project file default extension is used for setting project files-extension used as default
extension in File | Load project and File | Save project dialogs.
In group When current file is modified by another process can be set mode of reloading of
actually loaded (current) file. There are three choices:
1.
Prompt before reloading file
2.
Reload automatically
3.
Ignore change scanning of current file
Load file format allows to set mode of file format recognition for loading files. When
automatic file format is selected, program analyses format of loading file and test file for each
of supported formats, that are available in program. If file format matches one of supported
formats, the file is read to buffer in detected format.
Manual file format allows user to select explicitly wished file format from list of supported file
formats. File may be loaded no completely or incorrectly, if file format does not match to user
selected format.
Hex file options
This page contains several options for loading control by any of HEX formats.
The first option sets erasing buffer (with desired value) automatically before the loading by
any of HEX formats.
The second option sets a negative offset, which is used for data addresses modification by
loading from any HEX file so, that data can be written to existing buffer addresses.
Example:
A file contents data by Motorola S - format. A data block started at address FFFF0H. It is a S2
format with length of address array of 3 bytes. For all data reading you can set a value of
negative offset to FFFF0H. It means, that the offset will be subtracted from current real
addresses and so data will be written from buffer address 0.
Page 50
UEP 50
Rel. 3.00