Download OPERATOR`S MANUAL

ASSEMBLY
Qty.
Description
L
G
1
Hitch Pin, 1/2 in. diameter.
1
Large Hairpin Cotter
1
Lock Washer, 5/16 in.
2
Flat Washer, 5/16 in.
1
Standard Nut, 5/16 in.
9
Nylock Nut, 5/16 in.
4
Lock Nut, 1/4 in.
4
Push Connector, 5/16 x 5/8 in.
I
J
H
K
M
N
1
Spring
1
Flat Grip
1
Lift Link
E
O
D
P
O
Q
MX33923
3. Insert the threaded end of lock pin (G) into upper hole (H) in lift handle
(I) and secure using a 5/16 in. lock washer (J) and 5/16 in. standard nut
(K).
4. Install the flat grip (L) on the end of the lift handle.
5. Rotate the lift handle and assemble it to the lift link (E) through the lower
hole (M).
Hardware (Bag of Parts)
6. Install a 5/16 x 1-3/4 in. hex bolt (N) through the middle hole in the lift
handle (I), then install a 5/16 in. flat washer (O) onto the hex bolt on the
other side of the lift handle, as shown.
Qty.
Description
2
Bolt, 5/16 x 2-1/4 in.
2
Clevis Pin, 5/16 x 1-3/8 in.
2
Small Hairpin Cotter
4
Special Flat Washer
2
Nylock Nut, 5/16 in.
2
Standard Nut, 3/8 in.
2
Lock Nut, 3/8 in.
2
Vinyl Cap
7. Align the lift handle against the lock plate (P), with the lock pin in one of
the seven index holes at the top of the lock plate and the hex bolt through
the lower hole. Secure with spring (Q), 5/16 in. flat washer (O) and 5/16 in.
nylock nut (D). Tighten lock nut, then back off as necessary for proper
operation.
A
S
A
D
Assemble Front Frame and Lift Assembly
D
NOTE: Use hardware from skin pack for this sequence.
R
S
B
MX33924
8. Install the two tow tubes (R) into the upper frame assembly (A), and
secure with two 5/16 x 1-1/2 in. hex bolts (S) inserted from the outside,
and 5/16 in. nylock nuts (D) at the inside. Tighten hardware only fingertight at this time.
E
C
D
F
Assemble Hitch Components
NOTE: Use hardware from skin pack for this sequence.
A
MX33922
1. Align the upper frame assembly (A) with the brush housing assembly
(B) and secure on each side with two 5/16 x 1-1/2 in. carriage bolts (C)
(installed from the inside, as shown) and 5/16 in. nylock nuts (D). Tighten
hardware.
2. Insert lift link (E) into hole in cross tube (F), oriented as shown
Assembly - 4