1
Download IntesisBox - Intesis Software, S.L.
Transcript
IntesisBox® KNX – Mitsubishi Heavy Industries A.C. Manual de Usuario r2.0 esp 7. Códigos de Error Código de Error KNX Error en el Control Remoto 0 1 2 3 5 6 7 8 9 10 12 14 16 19 28 30 31 32 33 35 36 37 38 39 40 41 42 43 45 46 47 48 49 51 53 54 55 56 57 58 59 60 61 63 65532 65535 N/A E1 E2 E3 E5 E6 E7 E8 E9 E10 E12 E14 E16 E19 E28 E30 E31 E32 E33 E35 E36 E37 E38 E39 E40 E41 E42 E43 E45 E46 E47 E48 E49 E51 E53 E54 E55 E56 E57 E58 E59 E60 E61 E63 N/A N/A Descripción del error No active error Remote controller communication error Duplicated indoor unit address Outdoor unit signal line error Communication error during operation Indoor heat exchanger temperature thermistor anomaly Indoor return air temperature thermistor anomaly Heating overload operation Drain trouble Excessive number of indoor units (more than 17) by controlling one remote controller Address setting error by mixed setting method Communication error between master and slave indoor units Indoor fan motor anomaly Indoor unit operation check, drain motor check setting error Remote controller temperature thermistor anomaly Unmatched connection of indoor and outdoor unit Duplicated outdoor unit address No. Open L3 Phase on power supply at primary side Inverter primary current error Cooling overload operation Discharge pipe temperature error Outdoor heat exchanger temperature thermistor anomaly Outdoor/Ambient air temperature thermistor anomaly Discharge pipe temperature thermistor anomaly High pressure error Power transistor overheat Current cut Excessive number of indoor units connected, excessive total capacity of connection Communication error between inverter PCB and outdoor control PCB Mixed address setting methods coexistent in same network Inverter over-current error Outdoor DC fan motor anomaly Low pressure anomaly Inverter anomaly Suction pipe temperature thermistor anomaly High/Low pressure sensor anomaly Underneath temperature thermistor anomaly Power transistor temperature thermistor anomaly Insufficient in refrigerant amount or detection of service valve closure Anomalous compressor by loss of synchronism Compressor startup failure Rotor position detection failure / Anomalous compressor rotor lock Communication error between the master unit and slave units Emergency stop Initialization process. Communication error between MH-RC-KNX-1i and AC unit / Remote controller En caso de detectar un código de error que no aparezca en la lista, contacte el servicio técnico Mitsubishi Heavy Industries más próximo para obtener más información acerca del significado de dicho error. © Intesis Software S.L. - All rights reserved This information is subject to change without notice ® IntesisBox is a registered trademark of Intesis Software SL URL Email tel http://www.intesis.com [email protected] +34 938047134 52 / 59
