Download 4 - Pump SA Control Panel v1.0.1

UNIVERSAL SEMI-AUTOMATED 4 PUMP CONTROLLER
SETTINGS SCREEN
4
1
2
5
3
6
7
1. PUMP NAME DISPLAY : Displays the name of the pump that the settings on this
screen apply to .
2. TARGET RATE: When this button is pushed a keypad will appear on the screen.
This allows the operator to set an application target rate in ounces or milliliters per
minute. This option is unavailable while FLOW RATE MODE is on any setting other
than OFF.
3. PUMP PERCENTAGE RATE: When this button is pushed a keypad will appear
on the screen, enter a percentage value. This method disregards the flow meter
reading. It drives the pump to a specified percentage of the maximum pump speed.
4. SCREEN EXIT: This button is used to exit back to the previous screen.
It’s functionality is the same throughout the HMI display.
5. APPLICATION METHOD: Pressing one of these two buttons determines what
method the operator will use for an application rate. Ounces per minute or pump
speed. An X will display in the box indicating which method is currently used.
6. GENERAL CONFIG: Pressing this button takes the operator to the General
Configuration screen (see page 35).
7. PUMP CONFIGRATION: Pressing this button takes the operator to the Pump
Configuration screen (see page 37).
Page 34