Download Motion-activated Coach Light

Transcript
FINAL ASSEMBLY
TESTING AND ADJUSTMENTS
1. Push the wires into the junction box. Make
sure the wires from the fixture go through the
wire path and no wires get pinched.
2. Slide the fixture assembly onto the mounting
screws. Tighten decorative nuts removed in step
1 of Installation section securely against fixture
base.
1. Turn on the circuit breaker and light
switch.
Note: Sensor has a 1 1/2 minute warm up period
before it will detect motion. When first turned
on wait 1 1/2 minutes.
2.Set:
ON-TIME switch to TEST
SENSITIVITY switch to “M”
Decorative Nut
TEST 1 5 10 MIN
ON-TIME
Junction Box
Mounting Screw
3. Install one medium base light bulb (60 Watt
maximum).
4. Caulk around fixture base with silicone weather
sealant.
206873-01
5
LO - M - HI
SENSITIVITY