Download Motion-activated Coach Light
Transcript
FINAL ASSEMBLY TESTING AND ADJUSTMENTS 1. Push the wires into the junction box. Make sure the wires from the fixture go through the wire path and no wires get pinched. 2. Slide the fixture assembly onto the mounting screws. Tighten decorative nuts removed in step 1 of Installation section securely against fixture base. 1. Turn on the circuit breaker and light switch. Note: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on wait 1 1/2 minutes. 2.Set: ON-TIME switch to TEST SENSITIVITY switch to “M” Decorative Nut TEST 1 5 10 MIN ON-TIME Junction Box Mounting Screw 3. Install one medium base light bulb (60 Watt maximum). 4. Caulk around fixture base with silicone weather sealant. 206873-01 5 LO - M - HI SENSITIVITY