Download Airflo Mk3

Transcript
English
Airflo Mk3
MI0259 issue 9
Trouble shooting guide
Compressor does not run when ‘up’ is selected
on the push button hand control.
Battery State Indicator light flashing ‘Red’.
Ensure that the air hose from the product being
inflated is connected to the Airflo.
This happens when the compressor’s internal
temperature cut-out has tripped. Leave the Airflo
for 60-90 minutes to cool.
Compressor keeps stopping when trying to
inflate the lifting aid.
Compressor causes electrical interference with
another piece of electrical equipment.
Check that there are no kinks in the air hose.
Move either the compressor or other item further
away from each other until the interference
stops.
Battery State Indicator light flashing ‘Red/Green’.
This happens when the current overload cut-out
has tripped. Leave for 3 seconds to self reset.
Specifications
Airflo
Weight:
Input to Compressor:
Output pressure:
Battery:
Environmental protection:
Type B equipment
4.6Kg
12Vdc, 7Amp
0.35 bar (5 psi)
1 x 12Vdc - 2.3Ah (Valve Regulated Sealed Lead Acid)
recycle
IP51 (Airflo housing)
IP67 (Push-button hand control)
do not dispose
of in household
waste
This equipment has been tested and meets the requirements of current EMC legislation.
Charger
Input:
230Vac, 50 Hz 10.5 VA
Output:
15Vdc, 350mA
Internal protection:
200mA 250Vac Fuse;
Environmental protection: IP30
Double insulated Class II equipment
Thermal Fuse 125ºC 250Vac / 2A
freedom through lightweight solutions
7