1
Download INGECON SUN 3Play
Transcript
DC connection Ingeteam 4. Make the connection with a screw terminal marked with the polarity and numbering of the PV array. These terminals are marked as PV1+, PV1-, PV2+ and PV2-. Remember that not all models of the unit have the same nominal current for each input. 80 5. To make the connection, strip an 18-mm section of the cable. Using a tubular terminal is optional. 6. Screw in the terminal with a torque of 5 Nm. 7. Secure the packing glands without pulling on the cables. 8. The DC cables must remain without voltage while the unit door is open. ABI2011IQM01_A - Installation and usage manual
