Download Serefina - Installation

Note: If an optional Brick Liner Kit was purchased, install it now, per instructions provided in kit
5. Install the right front log onto the corresponding burner pin and
sub-floor right tab as shown in Figure 21.
2. Place the largest log onto the rear log stoppers (see Figure 17).
Ensure that the grooves on the bottom of the log aligns onto the
corresponding places on the rear log stoppers. Push the log back so
that it is against the back of the rear log stoppers (see Figure 18).
Rear
Log
Right Front Log
Figure 21
Figure 18
3. Place the left front log onto the corresponding burner pin and
sub-floor left tab as shown in Figure 19.
6. Install the left top twig onto the corresponding pin on the rear
log and align it with the indentation on the front left log as shown
in Figure 22.
Left Top Twig
Figure 22
Figure 19
Left Front Log
7. Install the center top twig onto the corresponding pin on the rear
log and align it with the indentation on front left log as shown in
Figure 23.
4. Place the center log piece over the corresponding pins next to the
front left log as shown in Figure 20.
Center
Top Twig
Center
Log
Piece
Figure 20
Figure 23
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
21