Download PDF - 7,58 MB

 INSTALLATION MANUAL
TERENA - TERENA16
Web Based Access Control
Quick Start Guide
TERENA & TERENA16
This central unit features a secure shutdown procedure.
If this procedure is not respected or if the battery is missing,
damage may de done to the sd card and its contents:
cdvi may not be held responsible for any loss of data.
Making backup copies of your data is therefore essential.
INSTALLATION
-Make the necessary wire connections for the central unit.
-Connect the cross-over network cable between the central control unit and the PC.
-Ensure that the SD card is properly inserted into the correct slot.
-Check the 4 DIP switch positions: Switches 1 and 4 should be in the ON position
and switches 2 and 3 in the OFF position.
You should never modify the 2-position dip switch terminal (switch 1 is off
and switch 2 is on)
-Connect the battery.
-Connect the central unit and switch it on (with the fuse holder inserted).
-Remove the lithium battery protection (CR2032) and install the battery.
-Wait a few moments and then check that the green light (PWR) comes on next
to the USB socket.
CONFIGURING YOUR PC
Assign a static IP address (IPv4) to the PC network card, for example: address
192.168.0.101, netmask 255.255.255.0 and leave the other fields empty.
CONFIGURING THE CENTRAL CONTROL UNIT
-Open the internet browser on your PC (minimum requirements: IE 8, FireFox 3.6,
Chrome 5, Safari 4 or Opera 10.5), Preferably, we recommend the use of Firefox.
2
cdvi.com
cdvigroup.com
EN