Download HYDROSONIC Hydrosilence
Transcript
EN MAINTENANCE CLEANING OF SURFACES See CLEANING INSTRUCTIONS manual attached. Replacing the remote control batteries To replace the batteries of the Remote Control, undo the four screws and remove the protective cover. Remove the spent batteries and replace with two new ones, type AAA-1.5V. Be certain to maintain the polarity as indicated when fitting the new batteries to the remote control. Refit the cover, taking care to position the waterproof seal correctly. Do not dispose of used batteries as normal refuse; place them in designated collection bins. CLEANING THE HYDROSONIC and WHIRLPOOL JETS Remove the jet cover (5) using the included tool. Then, with the aid of the relevant wrench (4), dismount the jet unit (3), removing its components. To clean the jets, use an anti-limestone, rinsing with water. When reassembling the jet unit (3), be careful that the gasket (2) is firmly positioned in its seat (1). For the jet to work properly, reassemble the ring nut, gently tightening it (do not exert excessive force). Delicately re-position the cover (5) on the jet, making sure the plaque fully locks into place all the way to the limit stop of its centering. OK NO OK NO 1 2 3 4 5 In the event of breakdown or malfunction (e.g. system fault, problems with pump, control unit, power unit... ) contact the nearest Teuco Authorized Service Centre (see list attached). The company will acknowledge no liability for damage to appliances that have been tampered with. HYDROSONIC - Hydrosilence 21