Download XE-A201
Transcript
10 Before Calling for Service The malfunctions shown in the left-hand column below, labelled “Fault,” do not necessarily indicate functional faults of the machine. It is therefore advisable to refer to “Checking” shown in the right-hand column before calling for service. Fault Checking (1) The display shows symbols that do not make sense. • Has the machine been initialized properly as shown “GETTING STARTED”? (Note that initialization clears all the data and programmed settings stored in memory.) (2) The display won’t be illuminated even when the mode switch is turned to any other position than “OFF”. (3) The display is illuminated, but the whole machine refuses registrations. (4) No receipt is issued. • Is power supplied to the electrical outlet? • Is the power cord plug out or loosely connected to the electrical outlet? • Is a clerk code assigned to the register? • Is the mode switch set properly at the “REG” position? • Is the paper roll properly installed? • Is there a paper jam? • Is the receipt function in the “OFF” status? • Is the print head release lever at the printing position? • Is the take-up spool installed on the bearing properly? • Is there a paper jam? • Is the journal printing selected in the printing style programming? (If the receipt printing is selected, the paper is not wound around the take-up spool.) (5) No journal paper is taken up. (6) Printing is unusual. • Is the print head release lever at the printing position? • Is the paper roll properly installed? Error code table When the following error codes are displayed, press the l key and take a proper action according to the table below. Error code Error status Action E01 Registration error Make a correct key entry. E02 Misoperation error Make a correct key entry. E03 Undefined code is entered. Enter a correct code E07 Memory is full (in the a key programming). Program the a key within 25 steps. E11 Compulsory depression of the s key for direct finalization Press the s key and continue the operation. E12 Compulsory tendering Make a tendering operation. E32 No entry of a clerk code Make a clerk code entry. E34 Overflow limitation error Make a registration within a limit of entry. E35 The open price entry is inhibited. Make a preset price entry. E36 The preset price entry is inhibited. Make an open price entry. E37 The direct finalization is inhibited. Make a tendering operation. E67 Subtotal void is not allowed. Finalize the transaction, and correct the wrong entries in the void mode. 67