Download Type 8030

Table 1:
66
40
54
Dimensions [mm] of the SE30 electronic
module
• Hall version
• 12-36 V DC, filtered and
regulated
• Hall Low Power
version
Dielectric strength
Current consumption
• 12-36 V DC, via transmitter
the device is connected to
2300 VAC
• Hall version
• 30 mA max.
• Hall Low Power
version
Protection against
polarity reversal
• 0,8 mA max.
yes
English
Protection against spike
voltages
Protection against short
circuits
Transistor output (Hall
version)
Transistor output (Hall
Low Power version)
English
yes
7.
yes
Safety instructions
pulse output, NPN and PNP,
open collector, max. 100 mA,
frequency up to 300 Hz, duty
cycle 1/2 ±10%
NPN output: 0,2-36 VDC
PNP output: supply voltage
pulse output, NPN, open
collector, max. 10 mA,
frequency up to 300 Hz, duty
cycle 1/2 ±10%
Electrical connection
Type of connector
cable type
female connector
type 2508 (supplied),
ordering code 438811
• 5 to 8 mm in diameter
18
Material
Supply voltage
9
16
Part
Electrical data
32
Fig. 1:
Materials
Housing, male fixed PC
connector
Female connector
PA / Stainless steel / NBR
type 2508 / screw /
seal
Fitting S030
refer to the operating instructions of the
fitting used.
44
06
08
15
20
25
32
40
50
65
H with fitting
S030
95,5
95,5
100,5
98
98
102
105,5
112
112
H
DN
Dimension H [mm] of the 8030 depending on
the DN of fitting S030
English
• shielded, max. 50 m
17
Installation and
commissioning
danger
Risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure
and drain the pipe before loosening the process
connections.
Risk of injury due to high fluid temperatures.
• Use safety gloves to handle the device.
• Stop the circulation of fluid and drain the pipe before
loosening the process connections.
Risk of injury due to the nature of the fluid.
• Respect the prevailing regulations on accident prevention and safety relating to the use of hazardous
products.
• wires between 0,25 and
1,5 mm2 in cross section
English
19