Download Dyna LED

2. Connecting/Disconnecting Handpiece
M500LG M4/B2, M600LG M4/B2
M500LG QD, M600LG QD
2-1 Connecting
1) Insert the handpiece into the hose connector.
2) Tighten the Hose Nut. (Fig.1)
2-2 Disconnect
Loosen the Hose Nut and pull out the Hose.
2-3 Connecting
1) Insert the Coupling into the Hose Connector.
2) Tighten the Hose Nut.
3) Pull the Connector Ring.
4) Push into the handpiece into Coupling.
Air Check Point
Handpiece
Hose Nut
Fig. 1
2-4 Disconnect
Slide back the Connector Ring as shown in Fig.2.
Air Check Point
Connector Ring
SUPPLY AIR PRESSURE Setting
Set the Air pressure at the “Air Check point” on Fig. 1 and Fig. 2 The setting values are on the specification
table. Do not exceed the recommended air pressure by using Multi Gauge.
Multi Gauge: Midwest 4 Hole Order code Z109400 / Borden2/3 Hole Order code Z109200
4
Handpiece
Hose Nut
Fig. 2