Download COMPACT 2.0 - Dirna Bergstrom
Transcript
COMPACT 2.0 Air conditioning for vehicles ES EN Solution • Check power cable and terminal connections. • Connect wire clamps (may be in the control panel or control module). ! (If the error persists, contact an Authorised Technical Service). • Take down the front and correctly connect the electronics in the keypad. • Check and correct the position of the battery power cables. • Replace fuse or connect. • Replace electronics. • Connect the compressor wire clamp. • Verify the load by checking the pressure; if it is below 0.5 bars or above 5.0 bars with the unit running, recover the load and empty for at least 30 minutes and introduce 300g in each circuit. • Clean the capacitor with pressurised air. • Connect or replace the electro. • Check whether the 2 terminals of the electro are connected in the control module. • Check the pressure; if it is below 0.5 bars with the unit running, clean each circuit or replace obstructed components (possibly the continuous flow capillary tube, as this is the component with least diameter). • Clean the valve and waste water pipe obstruction. • Seal the cabling output in the blower and coil cabin cover. * Gas recovery must be precise, since part of the gas remains in the tubes of the pressure gauges. 21