Download Nuvo V7 operating table

3.2.6
Integrated kidney bridge back section
Factory assembled kidney bridge back section adds more versatility to use the operating table on thorax
area procedures with simple adjustment of an adjustment crank handle. Become familiar using Kidney
bridge and body elevator before operation. Table top can be constructed normally with desired configuration.
Crank handle fixing
Kidney bridge and body elevator system
Crank handle for kidney
bridge adjustment
Insert the crank handle to the kidney bridge adjusting pin located either side of the back section. Check that
handle is fully inserted before adjusting. Start adjusting slowly counterclockwise to rising the angle. Adjust
until the proper angle is reached. Maximum height is about 150 mm.
Back section angle can be adjusted normally from the hand control unit or back-up-control panel. Long combined seat and back section mattress is used with the kidney bridge back section system.
WARNING! Notice, labeling of pinching risk which may occur If adjustment is made carelessly. Keep the
crank handle safe place and remove before operation and when operating table is transported.
21