Download AMS IFU format - AMS Labeling Reference Library

Transcript
Prosthesis Specifications
Instructions for Use
Compressed diameter
Reference diameter
6mm
14mm
Length at 14mm diameter:
Product number
72401800
72401801
72401802
72401803
72401804
72401805
Length
1.5cm
2.0cm
2.5cm
3.0cm
3.5cm
4.0cm
Caution: This device is to be used only by
urologists who have received appropriate training
regarding the use of the UroLume Prosthesis.
Pre-operative Set-up
The following materials are required for the
placement procedure:
• 12Fr, 0° to 12° telescope
• Water flushing setup: typically 1 to 5 litres on I.V.
pole, 5mm tubing
• Urethral sounds up to 26Fr
Delivery Instrument Specifications
• UroLume Prosthesis kits (two of each size
recommended)
Diameter
Outer shaft
Retractable sheath
Inner lumen
Rounded collar
22.5Fr
21.0Fr
12.0Fr
24.0Fr
Useable shaft length
For 1.5cm prosthesis
For 2.0cm prosthesis
For 2.5cm prosthesis
For 3.0cm prosthesis
For 3.5cm prosthesis
For 4.0cm prosthesis
20.7cm
20.7cm
19.5cm
18.5cm
20.5cm
20.5cm
“A” Position
ACMI (1.5-3.0 cm stents)
Storz (1.5-3.0 cm stents)
Wolf (1.5-3.0 cm stents)
“B” Position
ACMI (3.5-4.0 cm stents)
Storz (3.5-4.0 cm stents)
Wolf (3.5-4.0 cm stents)
“C” Position
Olympus (1.5-3.0cm stents)
To place the prosthesis in the bulbar or prostatic
urethra, these additional materials are required:
• 17Fr cystoscope
• AMS Urethral Measuring Catheter or a
graduated ureteric catheter
• Urethrotomy equipment (stricture only)
Note: A selection of at least two UroLume kits in
each size is advised. This inventory ensures that
the correct size is available when the prostatic
urethra is measured. Clinical investigators advise
repeating the prostate measurement to ensure that
an accurate measurement is obtained.
Note: 12º telescopes cannot be used with a telescope
stabiliser as they must be rotated to view the
anterior bladder neck during prosthesis
placement.
Premedication
Prior to implantation with the UroLume Prosthesis,
patients should be given prophylactic broadspectrum antibiotic coverage according to the
protocols commonly used by the hospital.
Patient preparation
Place the patient in a lithotomy position, prep with
aseptic solution and drape.
Figure 4a: Insert and remove the telescope
from the scope stabilizer, by grasping the
scope stabilizer as shown.
5